Red Arrows Hawk – Tail servo replacement & progress

Rather annoyingly the tail servo decided to break. Of all the servos this is the hardest to replace as its glued into the tail.

Had a look at getting it out from underneath. I just can’t get my fingers far enough in there. So moved to plan B, remove the rudder. Had it out in no time. I just need to make a new spar to mount the rudder to again. This will make it much easier to install a new servo as well.

Also created custom wing fences and rear fins as these were not part of the kit.

This entry was posted in Red Arrows Hawk. Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *