Junkers JU52/3 wing assembly

Done a bit more, built the other wing, attached it to the fuselage, made a 3mm depron tail which looks much more sturdy now.

To give an idea of size I put a CD case next to it:

Holding the wings at the right angle so that the epoxy/glass fibre can set properly

Next job will be control linkages, then motor position and electronics installation. After than it will be test flight. If successful it will get detail pieces. Otherwise back to the drawing boar

This entry was posted in Ju 52/3 and tagged , , . Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *