New hd video, running 5S and damper struts all round. ( also in HD )

Installed new landing gear that have springs built in. Look great. Went out for a test of the new gear. They do a great job of absorbing the bumps in the grass. I just dont have enough power. Couldn’t get … Continue reading →

Finally got back in the air again after the FOD incident on the second flight. I installed a Wemotec rotor into the original fan housing. I was planning to use the whole Wemotec fan unit however it would have needed … Continue reading →

I decided to use a slide catch at the back and made a tongue and slot at the front. At the back of the canopy I added a small bit of ply to strengthen the area where the slide catch … Continue reading →

A while back the HET nose wheel steering arm broke. The grub screw got stuck and the thread stripped when I was trying to remove it. After trying to get a replacement I decided to try and make my own. … Continue reading →

It went very well. I start from the end of field to give it as much run up as possible. The crops are quite high at this time of year so I needed to be a good 2.5 meters up … Continue reading →

Over the last few days I’ve finished everything of and finished the canopy today. CG has come in between 75mm & 80mm with out any extra weight in the back. The battery is right at the back of the battery … Continue reading →

Rather annoyingly the tail servo decided to break. Of all the servos this is the hardest to replace as its glued into the tail. Had a look at getting it out from underneath. I just can’t get my fingers far … Continue reading →